Projectiondesign F35 User's Guide download pdf (Page 29)

english

www.projectiondesign.com

6.6 Controlling screens with triggers

The projector has to programmable triggers with 3.5 mm2 mini-jack connectors. These can

be used to enable or disable screens, curtains or other peripheral equipment.

To change trigger settings, go to menu entry INSTALLATION > TRIGGER

By default:

• Trigger 1 is set to control a screen depending on whether projector is powered on or not.

• Trigger 2 is set to control a screen depending on the aspect ratio of currently active

source.

Both triggers can be manually overridden both in the menu system and by using the com-

mand and control protocol through RS-232 or LAN.

6.7 Setting aspect trigger behavior

To customize the aspect trigger functionality, go to menu entry INSTALLATION > TRIGGER >

ASPECT TRIGGER BEHAVIOR. In this sub-menu it is selectable for which input aspect ratios

the trigger will be enabled.

6.8 Automatic power on/off

The projector can be automatically powered on or off by using the internal timer function or

DPMS.

6.8.1 Using the timer

The projector features a real-time clock that enables timing control. This means that the

projector can be programmed to switch on and off at certain pre-set times during a weekly

cycle.

To allow for a ﬂexible schedule, 10 ‘programs’ are available. With each program, you can

deﬁne the switch on or switch off time for a single day (Monday to Sunday), all work days

(Monday through Friday), or week-end (Saturday and Sunday). One, several or all programs

can be active at the same time as desired. In this way, a ﬂexible scheme can be established.

Observe the 24 hour time format. For more information, see the SETTINGS > TIMER menu.

The following example illustrates a case where the projector turns on at 08:00 in the morning

(8 am) and switches off at 20:00 (8 pm) on weekdays (Monday through Friday). Weekends

(Saturdays and Sundays), it turns on at 10:00 (10 am) and off at 18:00 (6 pm). VGA is used

as the source. For this, four programs are needed, 2 for on and two for off.

6.8.2 Using DPMS (Display Power Management Signaling)

The projector is enabled for DPMS (Display Power Management Signaling). When enabled,

the projector will automatically switch to standby mode after a speciﬁed time if there is no

valid source present at its inputs. When a valid source is reconnected, the projector will start

up again.

To enable or disable DPMS, go to menu entry SETTINGS > DPMS. The desired DPMS time-

out is set in the DPMS > DPMS TIMEOUT menu entry.

DPMS is disabled by default.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 41 42

No comments

Projectiondesign F35 User's Guide Page 29